To p.66), About shooting distance information slider, Correcting multiple images at a time – Canon t2i 3.9 for Macintosh User Manual
Page 67: Cop y
66
O
When correcting RAW images shot with the cameras in the table below,
if shooting distance information has been saved to the image, the slider
is set automatically according to this shooting distance information.
However, if no shooting distance information is saved to the image, the
slider is set automatically to the right end at infinity position and a [<!>]
appears above the slider.
If the image’s shooting distance is not infinite, you can minutely adjust
the distance by operating the slider while looking at the screen.
O
When correcting RAW images shot with the cameras in the table
below, it is set automatically to the right end at infinity position. You
can then minutely adjust the distance by operating the slider while
looking at the screen if the shooting distance is not infinite.
O
For RAW images shot with MP-E 65mm f/2.8 1-5x Macro Photo or EF
50mm f/2.5 Compact Macro with Life Size Converter EF, the slider
indicator changes to [Magnification factor].
O
[Shooting distance information] slider is applied to all the correction
items with check marks.
EOS-1D Mark IV
EOS-1Ds Mark III
EOS-1D Mark III
EOS 5D Mark II
EOS 7D
EOS 60D
EOS 50D
EOS 40D
EOS REBEL
T2i/550D
EOS REBEL
T1i/500D
EOS DIGITAL REBEL
XSi/450D
EOS DIGITAL REBEL
XS/1000D
EOS-1D Mark II N
EOS-1Ds Mark II
EOS-1D Mark II
EOS-1Ds
EOS-1D
EOS 5D
EOS 30D
EOS DIGITAL REBEL
XTi/400D DIGITAL
_
About Shooting Distance Information Slider
Select multiple images to correct in the main window. Display tool
palette by clicking the [Tool palette] button
in the toolbar. If you
perform correction procedures
when tool palette is displayed, you
can apply the same corrections to all the images selected in the main
window.
Also, you can apply same corrections by copying the recipe of the
corrected image and pasting it onto the multiple images
O
Some noise appeared in the periphery of an image after
correcting [Peripheral illumination]
You can reduce the noise by using luminance and/or chromatic noise
reduction of the noise reduction function
. However, if you had
applied high amount of [Peripheral illumination] correction to the
images that have been shot at night or with a high ISO speed, the
noise might not be reduced.
O
The image appears with less resolution after correcting
[Distortion]
You can make the image similar to the one before correction by
applying more sharpness with the sharpness adjusting function
.
O
The colors of the image became weaker after correcting [Color
blur]
You can make the image similar to the one before correction by
adjusting the color tone
and/or the color saturation
to
make the color deeper.
O
The result of [Color blur] correction cannot be detected
[Color blur] correction is effective for correcting blue or red color blur
which occurs at the edge of the highlighted area of an image. If
conditions do not match, correction cannot be made.
Additional information
Correcting Multiple Images at a Time
The periphery of the image may be truncated when [Distortion]
correction is made.
For a list of the [Lens aberration correction] window functions, refer
to
.
COP
Y