Panasonic KX-TG4011 - Manual (Page 38)

Useful Information
38 For assistance, please visit http://www.panasonic.com/help
Programmable settings
Battery recharge
The unit does not work. L Make sure the batteries are installed correctly
(page 10).
L
Fully charge the batteries (page 10).
L Check the connections (page 10).
L Unplug the base unit’s AC adaptor to reset the
unit. Reconnect the adaptor and try again.
L
The handset has not been registered to the base
unit. Register the handset (page 23).
I cannot hear a dial tone. L The base unit’s AC adaptor or telephone line cord
is not connected. Check the connections.
L Disconnect the base unit from the telephone line
and connect the line to a known working
telephone. If the working telephone operates
properly, contact our service personnel to have the
unit repaired. If the working telephone does not
operate properly, contact your service provider/
telephone company.
Problem Cause/solution
The display is in a
language I cannot read. L Change the display language (page 13).
I cannot register a handset
to a base unit.
L
The maximum number of handsets (6) is already
registered to the base unit. Cancel unused
handset registrations from the base unit (page 23).
Problem Cause/solution
The handset beeps and/or
7
flashes.
L
Battery charge is low. Fully charge the batteries
(page 10).
I fully charged the
batteries, but 7 still
flashes or the operating
time seems to be shorter. L Clean the battery ends (S, T) and the charge
contacts with a dry cloth and charge again.
L
It is time to replace the batteries (page 10).
Problem Cause/solution
TG401x.book Page 38 Friday, December 3, 2010 1:36 PM