Casio CTK-691 - Manual (Page 43)

E-41
Mixer Function
3.
Use the [ ] and [ ] CURSOR buttons to
select the parameter whose setting you want to
change.
Example:
Select volume setting by displaying “Volume”.
Š Each press of the [ ] or [ ] CURSOR buttons
cycles through the parameters.
Š You can use the [ ] and [ ] CURSOR buttons
to change to another channel at any time during
this procedure.
1 Indicates channel volume of 127
4.
Use the number buttons or [+] and [–] to change
the parameter setting.
Example:
Change the setting to “060”.
Š Pressing the MIXER or EXIT button exits the
parameter edit mode.
1.
While Channel 16 is selected, press the [ ]
CURSOR button.
Š This selects the DSP channel.
Š Pressing the [ ] CURSOR button while the DSP
channel is selected returns to Channel 16.
The following are the parameters whose settings can be
changed in the Parameter Edit Mode.
z Tone (Range: 000 to 803, Drawbar organ tones 000 to 199)
This parameter controls the tones assigned to each part.
Anytime the tone is on the display, you can use the TONE
button or DRAWBAR ORGAN button and then select a
different tone, if you want.
z Part On/Off (Settings: on, oFF)
This parameter can be used to turn each part on (sounds) and
off (does not sound). The current on/off status of each part is
indicated on the display as described below.
z Volume (Range: 000 to 127)
This is the parameter that controls the volume of the selected
channel.
z Pan Pot (Range: –64 to 00 to +63)
This parameter controls the pan pot, which is the center point
of the left and right stereo channels. Setting “00” specifies
center, a value less than “00” moves the point left, and a value
greater than “00” moves it right.
Editing DSP Channel Parameters
How Parameters Work
Tone Parameters
705A-E-043A