Bissell 1190B - Manual (Page 13)

brush removal and large belt replacement (as needed)
brushes can be removed for cleaning or
replacement as needed.
1. Follow small belt removal instructions on
page 12 steps 1-7.
2. Remove brush rolls by pulling them off of
the metal rods. Be careful not to lose the small
washer at each end of the brush rolls.
3. Re-attach the large belt to the grooves on the
end of the new or cleaned brush rolls. if the belt
is damaged, replace with a new belt.
4. Place cleaned or new brush rolls back onto
the rods. Make sure one washer is on each end
of the rollers prior to sliding onto the rod. be
sure the brush is seated completely on the rod.
5. Replace small belt over grooves in back roller
and metal cog.
6. Replace pivot arm and secure with
silver screw.
7. Re-attach end cap by tightening with the
(3) black screws.
8. Replace the nozzle assembly back onto the
machine. Refer to step 2 on page 9.
if you have any questions or are having trouble
installing or replacing your belt(s) or brushes,
please call BISSeLL Consumer Care.
Maintenance & Care
WARNING
To reduce the risk of electric shock, turn power switch
off and disconnect plug from electrical outlet before
performing maintenance or troubleshooting checks.
www.bissell.com
13
2.
4.
6.
3.
5.
7.