Bissell 22K7B - Manual (Page 8)

w w w. b i s s e l l . c o m
O
perations
8
Before you clean
1. Move furniture to another area if cleaning
an entire room (optional).
2. Vacuum area with a dry vacuum cleaner
thoroughly before deep cleaning.
3. Pretreating (optional):
3a. Pretreating is recommended to improve
cleaning effectiveness for heavily soiled
carpet in high traffic areas such as
entryway and hallways.
3b. BISSELL Tough Stain precleaner
Spray the BISSELL Tough Stain
precleaner formula onto heavy traffic
areas, soiled areas or stains.
Allow to penetrate for at least 3 minutes.
Clean as normal, using the deep
cleaner in upright mode, following the
instructions below.
Upright cleaning mode
Filling formula & water tank
1. Remove tank from the base of the machine
by lifting up tank carry handle.
Note: This tank was designed with a flat
bottom so it can be easily filled.
2. Unscrew the black cap and remove bottle
insert.
3. Fill tank with hand hot tap water to the
water fill line. Add 60 mL of BISSELL 2X
formula to the tank.
4. Replace the bottle insert in the tank and
tighten the black cap. Replace the tank on
the deep cleaner.
Cleaning
1. Plug into a proper outlet and press the
power button. Allow 1 minute for the hot
water heater to warm-up before cleaning.
2. While pressing the spray trigger, make one
slow forward wet pass and another one back.
ATTENTION:
Some Berber carpets have a ten-
dency to fuzz with wear. Repeated
strokes in the same area with an
ordinary vacuum or deep cleaner
may aggravate this condition.
1.
3b.
2.
WARNING:
To reduce the risk of fire, use only
BISSELL deep cleaning formula for
full size machines in your deep
cleaner. Use of cleaning formulas
that contain lemon or pine oil may
damage this appliance and void the
warranty. Chemical spot cleaners or
solvent-based soil removers should
not be used. These products may
react with the plastic materials used in
your deep cleaner causing cracking
or pitting.