Bissell 3698E - Manual (Page 5)

www.bissell.com
5
Getting ready
1. To fill clean water/formula tank
a. Remove tank by lifting it straight
up and away from unit.
b. Pull on black tab to reveal tank
opening. The plug rotates out of the
way for easy filling.
c. Your tank is marked for a large stain or a
small stain. based on your cleaning need, fill
with hot tap water to the water fill line. Add
Oxygen boost formula to the OXYgen boost
fill line. Add bissell 2X formula to formula
fill line. DO NOT BOIL OR MICROWAVE
WATER.
d. Replace plug by rotating into place and
pressing gently onto tank.
e. Replace tank by lining up tank
bottom with indentations on machine. Press
down firmly on tank to secure
in position.
2. Release hose from hose grip bracket. Unwrap
hose completely from around unit.
3. insert desired tough stain tool on end of hose
until it clicks into place.
4. Twist the Quick Release™ cable wrap clockwise
to unwrap power cable completely.
pretreating
Cleaning effectiveness will be enhanced if you
pretreat heavily stained or highly soiled areas.
Here’s how to do it.
1. Hold cleaning tool just above surface of carpet
or upholstery to be cleaned. Press spray trigger
to release a spray of cleaning solution directly
onto stained or soiled area.
2. Wait 3-5 minutes before cleaning.
cleaning with your spot cleaner
1. Plug unit in and turn on by pressing power
button under handle.
2. Hold cleaning tool approximately 2.5cm above
soiled surface. Press spray trigger to apply
cleaning solution to soiled area.
3. Using brush on cleaning tool, gently scrub
area to be cleaned.
4. For thorough cleaning, spray additional
solution while brush and suction are in
contact with surface.
5. Apply downward pressure on cleaning tool
and pull it toward you. The suction will remove
the dirt and cleaning solution. Continue until no
more dirt can be removed.
WARNING
Keep spray away from face. Failure to do
so may result in personal injury.
ImpoRtANt
Check the manufacturer’s tag before
cleaning upholstery. “W” or “WS” on the tag
means you can use your SpotClean. If tag
is coded with an “S” (with diagonal strike-
through), or says “Dry Clean Only,” do not
proceed. If manufacturer’s tag is missing or
not coded, check with your furniture dealer.
Operations
1a.
1b.
3.
4.