Bissell 3698E - Manual (Page 6)

6. As a final step, use “drying strokes” (by not
pressing the spray trigger) to remove as much
liquid/moisture as possible. Repeat this step as
often as necessary.
7. When using Oxygen boost formula, it will
continue to work for the next six to eight hours
cleaning your spots and stains all the way to
the backing of the carpet.
machine care
1. Unplug power cable from electrical socket.
2. empty and rinse dirty water tank after each
use, OR when dirty water reaches indicated
maximum fill line.
a. lift tank up and away from base
of machine.
b. Pull tab to remove plug from tank
c. Rinse out tank with clean water
after emptying.
d. Disconnect cleaning tool from hose grip
by pushing down on button lock and pulling
straight off. (Do NOT twist cleaning tool to
remove it).
e. The front nozzle of the small tough stain
tool can be removed for easy cleaning. Push
button at top of cleaning tool and slide front
nozzle off top of cleaning tool. Rinse both
with clean water and replace front nozzle
back on cleaning tool. Rinse all other cleaning
tools used with clean water.
f. Check spray nozzle for accumulated dirt
or debris. if necessary, clean with soft bristle
brush.
g. The float stack can be removed from
inside dirty water tank for cleaning. Turn
locking assembly anti-clockwise to unlock
position and pull down and out of tank
to remove. Rinse with clean water until all
debris is removed. Replace float stack back
inside dirty water tank and turn locking
assembly clockwise to lock position.
machine storage
Water and cleaning formula can be left in clean
water tank for next use.
1. Wrap power cable around cable wrap
on back of machine.
2. Wrap hose around the base of unit and
secure the hose grip.
3. store unit in protected, dry area, at room
temperature (4° to 43°C).
Operations
www.bissell.com
6
Maintenance & Care
WARNING
To reduce the risk of electric shock, turn power button
off and disconnect plug from electrical outlet before
performing maintenance or troubleshooting checks.
WARNING
To reduce the risk of electric shock, always install float
stack before any wet pick-up operation.
2e. 2g.