Bissell 40N8 - Manual (Page 5)

5
w w w . b i s s e l l . c o m
A
ssembly
Handle
1. Connect hose to vacuum by inserting hose
connector on the end of the hose into the
suction inlet. Make sure the hose is
positioned so the tabs on the hose connector
line up with the notches on the suction inlet.
Once inserted into the suction inlet, turn
counter clockwise to lock into place.
2. Attach extension wands section together
by inserting into one another and twisting
slightly to tighten.
3. Connect hose handle to the end of the
extention wand and twist slightly to tighten.
4. Connect floor nozzle to the end of the
extension wand and twist slightly to tighten.
5. Once assembled, you can store your
vacuum by inserting the storage clip (located
on the back of the floor nozzle) into the
storage slot on the rear of the vacuum.
1.
5. 4.
3.
2.
WaRNING:
Plastic film can be dangerous.
to avoid danger of suffocation,
keep away from babies and
children.
Suction Inlet