Bissell 61Z4 - Manual (Page 10)

w w w. b i s s e l l . c o m
M
aintenance and care
10
cleaning the dirt container
additional steps can be taken to clean
the dirt container as necessary.
1. Ensure the dirt container has been
emptied.
2. Remove the lower portion by pressing the
front latch on the upper portion as shown.
3. Clean the screen with a cloth or soft brush
to remove dust or debris.
4. If desired, the lower dirt container may be
washed in warm water. Make sure it is
completely dry before reassembling.
do not put in dishwasher.
5. To reassemble, hold the carry handle and
place the upper portion into the lower
portion, lining up the front and back
latches. Push down until both latches click
into place. Make sure the dirt container is
securely assembled before replacing it on
machine.
cleaning the pre-motor filter
the pre-motor filter should be checked
monthly and washed as needed to
maintain performance. More or less
frequent cleaning may be required
based on individual vacuuming habits
and types of debris picked up .
1. The filter is located in the door labeled
"Filter" behind the dirt container. Push the
tab at the top and swing the door down
to access.
2. Remove foam filter and hold under
running water to wash. Mild detergent
may also be used if desired. Wring
excess water from filter.
allow filter to air dry completely
before replacing.
WARNING:
Do not operate the vacuum with
a damp or wet filter or without
all the filters in place.
WaRning:
To reduce the risk of
electric shock, turn power
switch OFF and disconnect
polarized plug from electri-
cal outlet before performing
maintenance or
troubleshooting checks.
3.
5.
2.
1.