Dogtra eF-3000 Gold - Manual (Page 8)

13
COLLAR
12
COLLAR
PROPER FIT
The collar should be fitted so that the surgical stainless steel contact
points press firmly against the dog’s skin. You should be able to fit a
finger in between the contact point and your dog’s skin. The best location
is either side of the dog’s windpipe.
IMPROPER FIT
A loose fit can allow the collar to move around on the dog’s neck. When
this happens, the contact points may rub the skin and cause irritation. If
the collar is too loose, electrical contact will be inconsistent and your
corrections will be inconsistent also.
Dogtra uses surgical stainless steel contact points and Anti-microbial
plastic to protect the dog’s skin.
ATTENTION!
Leaving the collar/receiver in the same location on the dog’s neck, for an
extended period of time can cause skin irritation. If the dog is to wear the
e-collar for long periods, occasionally reposition the collar so that the
contact points are moved to a different location on the dog’s neck. Make
sure you check for skin irritation, each time you use the unit.
Collar/Receiver Battery Charging Receptacle
On the inside of the collar receiver, next to the collar strap, is a battery
charging receptacle with a rubber plug.
The unit will be fully waterproof with or without the rubber plug. If the
dog was in salt-water, be sure to rinse the receiver and charging port with
clean water, and let air dry.
Adaptor
The battery charger is designed for a 120-volt wall outlet. (An European
220-volt AC charger is also available.)
Transmitter Adaptor
(25-Volt 500mA)
Receiver Adaptor
(5Volt 1A)