Customizing features/options, Recharge now, Recharge tonight – EcoPure MW_MW30_450224 User Manual
Page 20
20
Miracle Water Installation & Operation Manual
Customizing Features/Options
Recharge Now
If you have guests, or other times when more water than usual is used, you could begin to run out of
conditioned water. If the unit is not scheduled to regenerate for another day or two, you could get hard
water until then. If this occurs, do the following to start an immediate regeneration.
• Press and hold the (Recharge) button until RECHARGE NOW flashes in the display, and
the softener enters the fill cycle of regeneration right away. RECHARGE NOW will flash during the
regeneration. When over, full water conditioning capacity is restored.
RECHARGE NOW Initiated
NOTE:
Avoid using hot water while the conditioner is regenerating, because the water heater will
refill with bypass hard water.
Recharge Tonight
If you do not want to start an immediate recharge, but would like an extra recharge at the next preset
recharge time, do the following to schedule a recharge.
• Press and release (do not hold) the (Recharge) button. RECHARGE TONIGHT flashes in
the display, and the softener will recharge at the next recharge time. RECHARGE NOW will flash
during the regeneration. When over, full water conditioning capacity is restored.
RECHARGE TONIGHT Initiated
Timer “Power-Outage Memory”
If electrical power to the timer is lost, ‘‘memory’’ built into the timer circuitry will keep all settings for
up to six hours. While the power is out, the display is blank and the unit will not regenerate. When
electrical power is restored, the following will occur.
1. You have to reset the present time only if the display is flashing. The HARDNESS and
RECHARGE TIME never require resetting unless a change is desired. Even if the timer is incor-
rect after a long power outage, the softener works as it should to keep your water soft. However,
regenerations may occur at the wrong time of day until you reset the timer to the correct time of
day.
NOTE: If the unit was regenerating when power was lost, it will now finish the cycle.
RECHARGE
RECHARGE