Edge Lighting Crystal Galaxy - Manual

FJ-CRYGA16-12-SN
Installation Instructions for Crystal Galaxy
1
904-FJ-CRYGA16-01
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
© 2012 Edge Lighting. All Rights Reserved.
SAVE THESE INSTRUCTIONS!
- Use this fixture indoors only.
- RISK OF FIRE: Use only the type of lamp and maximum
wattage indicated in this instruction manual.
- This product is ETL listed for indoor dry locations and
approved to be used at any height above the finished
floor.
IMPORTANT INFORMATION
Adjust the Fixture Height
A
H
1: Cut the coaxial cable to the desired height (H) with a sharp
cutter. The overall fixture height is measured from the
bottom of the crystals to the end of the coaxial cable.
B
M4 SET SCREW M3 SET
SCREW
1.5MM ALLEN
WRENCH 2MM ALLEN
WRENCH
2
3
COAXIAL FIXTURE CONNECTOR
2: Loosen the M4 set screw on base of the coaxial fixture
connector with the 2mm Allen wrench provided. Do not
remove this set screw.
3: Remove the M3 set screw on tip of the connector with the
1.5mm Allen wrench provided.
CRYSTAL
COAXIAL CABLE
1