Edge Lighting Crystal Galaxy with Downlight - Manual

CRYGA__-12-__SN
Installation Instructions for Crystal Galaxy Suspension
and Crystal Galaxy Suspension with Downlight
1
904-CRYGA-01
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
© 2014 Edge Lighting. All Rights Reserved.
SAVE THESE INSTRUCTIONS!
- Do not install fixture assemblies closer than six inches, or
as specified in the fixture installation instructions, to
curtains or similarly combustible materials.
- Ensure that power to the junction box is OFF before
beginning any electrical work.
- RISK OF FIRE: This product must be installed by a
qualified electrician. Turn the power to the electrical box
off during installation.
- RISK OF FIRE: Use only the type of lamp and maximum
wattage indicated in this instruction manual.
- This product is ETL listed for indoor dry locations and
approved to be used at any height above the finished
floor.
- This product is suitable only for indoor dry locations and
approved for the use at any height above the finished floor.
- This product contains a magnetic transformer with a built-in
dimming coil.
- This product may be dimmed only with a low voltage
magnetic dimmer. Using a dimmer other than specified may
work initially, but will eventually cause transformer failure
and void the warranty. The dimmer must be derated as
indicated by the dimmer manufacturer.
- Load the circuit of the surface mount transformer to
rated capacity only.
GENERAL INFORMATION IMPORTANT SAFETY INSTRUCTIONS
Determine and Adjust Fixture Height
A
H
1: Push the suspension cable into the center mounting standoff
to determine the desired height from the mounting surface
of the power supply to the bottom of the fixture. Refer to
Figure H for more details.
CRYSTAL
SUSPENSION
CABLE
1
CRYGA__-12-__-DL-SN