レリーズベアリング取付け手順, Release bearing installation procedure – EXEDY Carbon Single User Manual
Page 11

H310 -
11
-
レリーズベアリング取付け手順
(ベアリングを容易に取付けるため、以下の手順に従って作業願います。)
Release bearing installation procedure
(To install the bearing easily, follow the instructions below.)
1. Remove the clutch disc which comprises [2],
[3], [7], and [8], and place the spacers at the
three positions on the flywheel equally
(positions of the knock pins).
Temporarily insert the release bearing from
the inside of the clutch cover.
2.
Tighten the bolts [5] in the structural
drawing diagonally not at a time, but
for several times with equal force,
until the flywheel comes in contact
with the clutch cover.
As the bolt is tightened up, the lever
is raised up. The lever tip should be
fit to the proper groove of the
bearing.
3. When the bolt [5] in the structural
drawing is loosened while the
bearing is supported with your
hand, the lever is lowered, and
the bearing is fixed.
Use a spacer with a diameter of approximately 20
mm and thickness between 6.5 mm and 7.0 mm.
It is acceptable that nuts or washers piled up to fit to
the space are used as substitutes.
As the lever is raised, the inner
diameter of the lever tip is increased,
and the bearing can be easily set to
the proper position.
4.
フライホイール(F/W)の取付け
Installation of flywheel (F/W)
1) 日産車、トヨタ車、スバル車、三菱車、ホンダ車
構成図④の F/W の取付けは 8-9 ページの一覧表にて指定のクランクボルト(FW 取付けボルト)を
必ず御使用下さい。
Nissan, Toyota, Subaru, Mitsubishi, and Honda vehicles
At the time of installation of the flywheel No. 4, be sure to use the crank bolt (flywheel mounting
bolt) specified in the list in page 8-9.
トヨタ車のクランクボルトのねじ山部には、必ずアドヘシブ 1324 を塗布して締め付けてくださ
い。
塗布せずそのまま締め付けるとエンジンオイルがボルト穴よりにじみ出ます。
Be sure to apply "Adhesive 1324" to the thread ridges of the crank bolt for the Toyota vehicle
before tightening it.
Otherwise, engine oil will ooze from the bolt hole.
クランクボルトは、対角順に数回に分けて、均等に締め付け、最後に規定トルクに合わせて、
本締めを行って下さい。
Tighten the crank bolt diagonally not at a time, but for several times with equal force. Finally,
tighten up it with the specified torque.
Bearing temporarily
inserted
Spacer
Bolt
Bolt
Bearing