FASS T UIM 095G - Manual (Page 20)

A. Bolts and fasteners properly tightened?
B. Electrical harness and fuel lines secured and properly tightened?
C. Has the system been primed, refer to owners manual?
D. Check for leaks.
E. Start the engine
F. Recheck all fluid and filter connections for leaks
G. Product registration filled out and ready to be mailed or faxed.
B. Weld a Bung Fitting
1. Fire Hazard, must be accomplished by a professional.
A. Most Preferred & Easiest
1. Drill and tap a 3/8”fpt in the thicker band of aluminum as seen.
2. If possible, install the fuel tank vent in this port and connect the FASS
(Bung fitting)
Note: The Red Plastic Plugs located in the “H” ports can stay in place fuel will not flow
through these ports. Coolant can be plumbed into these ports to heat the fuel in the Winter
months.
To assist with priming your FASS pump crack the FWS-3003. Put power to the FASS pump to
activate the pump. When the tone of the pump changes you can tighten up the fuel filter. If you
need a video of the priming process go to www.FASSride.com.