FASS T UIM 095G - Manual (Page 3)

FASS Recommended Application
T UIM 095G Class 1– Class 7, Agriculture, Industrial, Recreational, Hwy and off-road.
Applications requiring fuel flow demands of 16psi and less than 95gph
T UIM 150G Class 1– Class 8, Agriculture, Industrial, Recreational, Hwy and off-road.
Applications requiring fuel flow demands of 16psi and less than 150gph
¡WARNINGs!
WARNING: Do not tie FASS Return in
with engine return. Back pressure can
cause damage to engine.
 Read all instructions before starting installation of this product!
 Installing the improper FASS Pump can cause severe engine damage.
 Use this (T UIM 095G or T UIM 150G) kit to prevent fuel flow into any ‘open’ injectors
during start-up.
 Once crankcase pressure is observed, power will be applied to the FASS pump.
 Operating your engine without the oil pressure switch (included) may cause engine damage.
 Do Not Remove any factory installed secondary fuel filter! Removal of a factory installed
secondary fuel filter may void the engine manufacturer’s warranty. This is the fuel filter
between the engines fuel pump and the injectors.
 Be sure that the serial # on this installation manual matches that of the outside of the box.
 Keep debris from entering the internals of the system during installation. Getting debris in
the water separator nipple can lock up the motor. If the motor does lock up from debris call
FASS for technical assistance.
 Properly secure lines to prevent chaffing.
 Use caution when drilling. Steer clear of any electrical wires , air lines or other damageable
components.