FLO~PRO 301008 - Manual (Page 4)

STEP 1: Un-hook negative battery terminals & drain
engine coolant.
STEP 2: Remove the plastic engine cover by removing
the four 8mm bolts as well as the dipstick.
STEP 3: Loosen the two V-Band clamps and remove
the 10mm bolt in the center of the tube. Then
disconnect the sensor plug and remove the
EGR crossover tube. (Fig. 1)
STEP 4: Remove the electrical connector on the EGR
valve (Circled in Fig. 2) then remove the EGR
valve itself which is held in place with four
10mm bolts.
Preparation
Fig. 1 Fig. 2
EGR Valve