Interior equipment, Integrated universal remote control – BMW Z4 sDrive35is 2011 User Manual
Page 101
Interior equipment
Integrated universal remote
control*
The concept
This system can replace up to three different
hand-held transmitters for various types of re‐
mote-controlled equipment, such as garage
doors or lighting systems.
The hand-held transmitter signal can be pro‐
grammed on one of the three memory buttons.
The corresponding device can then be operated
using the programmed memory button.
The LED indicates that a signal is being trans‐
mitted.
When selling the vehicle, delete the stored pro‐
grams for security reasons.
During programming
During programming and before activat‐
ing a device using the universal remote control,
ensure that there are no people, animals, or ob‐
jects in the range of movement of the remote-
controlled device; otherwise, there is a risk of
injury or damage.
Also follow the safety instructions of the hand-
held transmitter.◀
Compatibility
If this symbol is printed on the packaging
or in the instructions of the hand-held
transmitter, the remote-controlled de‐
vice is generally compatible with the universal
remote control.
If you have any questions, please contact:
▷
Your service center.
▷
www.homelink.com on the Internet.
Programming
1 Memory buttons
2 LED
Fixed-code hand-held transmitters
1.
Switch on the ignition.
2.
Initial setup:
Press both outer buttons 1 for ap‐
prox. 20 seconds until the LED flashes.
All programs of the three memory buttons 1
are cleared.
3.
Hold the hand-held transmitter at a distance
of approx. 2 to 8 in/5 to 20 cm from the mem‐
ory buttons.
4.
Simultaneously press the transmit button of
the hand-held transmitter and the memory
button of the universal remote control.
The LED flashes slowly.
5.
Release both buttons when the LED flashes
rapidly.
If the LED does not flash rapidly after approx.
15 seconds, change the distance and repeat
the step.
The device can be operated using the memory
button with the engine running or the ignition
switched on.
Malfunction
If the device cannot be used after repeated at‐
tempts at programming, please check whether
the hand-held transmitter is equipped with an
alternating code system.
Seite 101
101
Online Edition for Part no. 01 41 2 604 231 - 03 10 500