BMW 335i Convertible 2009 - Manual (Page 221)

M
o
bi
lity
219
Refere
nce
At a glan
ce
Co
n
tr
o
ls
Dr
ivi
n
g ti
ps
Co
mm
un
icat
io
ns
Navigation
Ente
rt
ai
nme
n
t
1. Turn the wheel inwards.
2. Partially release the cover in the wheel well.
To do so, remove the corresponding
screws, see arrows.
3. Pull the cover back.
Parking lamps and roadside parking
lamps, daytime running lamps
H8 bulb, 35 watts
1. Remove the cover, refer to Access to the
bulbs.
2. Turn the bulb approx. 90°, see arrow, and
take it out.
3. Disconnect the plug, change the bulb and
reconnect the plug.
4. Insert the bulb and turn it until it stops.
5. Reattach the cover.
Corner-illuminating lamp*
H3 bulb, 55 watts
1. Switch off the lamps and take the remote
control out of the ignition lock.
2. Remove the cover, refer to Access to the
bulbs.
3. Push the wire bracket out of the anchor
towards the right and fold it up.
4. Disconnect the plug, change the bulb and
reconnect the plug.
5. Insert the bulb.
6. Fold the wire bracket down and engage it.
7. Reattach the cover.
Turn signals, front
21-watt bulb, PY21W
or PY21W Silver Vision
1. Release the cover in the wheel well, refer to
Access through the wheel well on
page
218 .
2. Rotate turn signal bulb socket 1 to the left
and remove.
3. Apply gentle pressure to the bulb while
turning it to the left for removal and replace-
ment.
4. Insert turn signal bulb socket 1.
5. Reattach the cover in the wheel well.
Online Edition for Part no. 01 41 2 600 967 - © 09/08 BMW AG