BMW M6 Convertible 2008 User Manual
Page 223
221
Spare wheel*
1.
Fold up the convertible top compartment
floor, refer to Convertible: increasing lug-
gage compartment capacity, page
.
2.
Pull back lock
1, fold open tensioning lock 2
completely and loosen the belt
3.
3.
Remove the cover
4.
4.
Take the tool mounting out of the spare
wheel.
5.
Remove the spare wheel.
Preparing wheel change
1.
Observe the safety precautions above.
2.
Prevent the vehicle from rolling:
Place the chock behind the front wheel on
the other side of the vehicle, or on inclines,
in front of this wheel. On steeply inclined
roads, always secure the vehicle against
rolling.
3.
Loosen the lug bolts a half turn.
Jacking up vehicle
The jacking points for the car jack are located in
the positions shown.
1.
Position the vehicle jack at the jacking point
closest to the wheel so that the entire sur-
face of the jack base rests on the ground
perpendicularly beneath the jacking point.
The vehicle jack is designed for
changing wheels only. Do not attempt
to raise another vehicle model with it or to
raise any load of any kind. To do so could
cause accidents and personal injury.
<
2.
Guide the jack head into the rectangular
recess of the jacking point when cranking
up, refer to illustration detail.
3.
Jack the vehicle up until the wheel you are
changing is raised from the ground.
Mounting a wheel
1.
Unscrew the lug bolts and remove the
wheel.
2.
Remove accumulations of mud or dirt from
the mounting surfaces of the wheel and
hub. Also clean the lug bolts.
3.
Position the new wheel or spare wheel.
Secure the wheel by screwing at least two
lug bolts into opposite bolt holes.
When you mount wheels other than Genu-
ine BMW light-alloy wheels, different lug
bolts may also be required.
4.
Screw in the remaining lug bolts. Tighten all
the bolts securely in a diagonal pattern.
5.
Lower the vehicle and remove the jack from
beneath the vehicle.
Online Edition for Part no. 01 41 0 014 244 - © 08/07 BMW AG