BMW X3 3.0si SAV 2007 - Manual (Page 77)

Re
fe
re
n
c
e
A
t a
g
lanc
e
Co
n
tr
o
ls
D
riv
in
g tip
s
M
o
b
ilit
y
75
Cargo area cover
Pull the cargo area cover out by the handle and
hook it into the rear holders.
You can carry light objects such as articles of
clothing on the cargo area cover.
Never place heavy, hard objects on the
cover. If you do so, they could endanger
passengers during braking or evasive maneu-
vers.
Do not allow the cover to snap back into place;
this can damage it.
<
Removal
1. Press the side buttons, refer to arrow 1.
2. Pull the case toward the rear, refer to
arrow
2.
Installation
Push the case forward into the two side holders
until it locks into place.
Stowing* when rear backrest is folded
down
Holders for the case are mounted on the backs
of the rear seat backs, refer to arrows
1.
Guide the case in from the right side until it
locks into place, refer to arrow
2. As you do this,
the cargo area cover must always point in the
direction of travel and the loop of the partition
net must point upward.
You can pull out the partition net and insert it
into the holders in the roof area above.
Partition net*
Do not allow the partition net to snap back
into place; otherwise, there is a danger of
injury and the partition net could be damaged. <
Hooking partition net into place
Pull the partition net out of the case by the
strap. Press the ends of the bar toward each
other, refer to arrows
1, and insert into the
brackets. Then press the bar all the way upward
in the middle, refer to arrow
2, so that it engages
in the brackets.
Online Edition for Part no. 01 41 0 013 638 - © 03/07 BMW AG