BMW X3 3.0si SAV 2007 User Manual
Page 79
77
1 Bracket
2 Telescoping rail
3 Recess in the cargo area rail
Inserting brackets
The two brackets are connected by a telescop-
ing rail.
1.
Insert each of the brackets into the respec-
tive recess in the rail on the cargo area floor.
2.
Press the brackets down to slide them into
the desired position.
3.
Make sure the brackets have seated
securely. They must engage audibly.
Do not place any cargo on the brackets;
this can cause them to disengage.
<
Dividing cargo area
You have the following possibilities for place-
ment of the cargo:
>
between the backrest and the telescoping
rail
>
between the telescoping rail and the retain-
ing strap
Positioning the cargo between the telescoping
rail and the retaining strap:
1.
Place the cargo against the telescoping rail.
Press the button, arrow
1 and pull the
retaining strap around the cargo, arrow
2.
2.
Hook the retaining strap to the recess
3 on
the telescoping rail.
3.
Press the button on the bracket, arrow
1.
The retaining strap is pulled tight.
You can also hook the two retaining
straps to each other.
After use of the adaptive attachment system,
roll the retaining strap back in and slide the
attachment system toward the front in order to
be able to make the best use of the cargo
area.
<
Removing brackets
Press down on the brackets, slide them to the
recesses in the rails, and remove.
You can also hook the two retaining
straps to each other.
<
Online Edition for Part no. 01 41 0 013 638 - © 03/07 BMW AG