Towing and tow starting, Giving and receiv ing as sistance – BMW 750i Sedan 2006 User Manual

Page 216

Advertising
background image

Giving and

receiv

ing

as

sistance

214

4.

Attach one negative/– clamp of the jumper
cable to the negative battery terminal or to
an engine or body ground of the assisting
vehicle.
Your BMW has a special nut that serves as a
body ground or negative terminal, refer to
arrow

2.

5.

Attach the second negative/– clamp of the
jumper cable to the negative battery termi-
nal or to an engine or body ground on the
vehicle to be started.

Starting engine

1.

Start the engine of the assisting vehicle and
allow it to run for several minutes at a fast
idle.

2.

Start the engine on the other vehicle in the
usual way.
If the first start attempt is not successful,
wait a few minutes before another attempt
in order to allow the discharged battery to
recharge.

3.

Allow the engines to run for several min-
utes.

4.

Disconnect the jumper cables again in the
reverse sequence.

If need be, have the battery checked and
recharged.

Never use spray fluids to start the
engine.

<

Towing and tow starting

Observe applicable laws and regulations
for tow-starting and towing.

<

Do not transport any passengers other
than the driver in a vehicle that is being

towed.

<

Using tow fitting

The threaded tow fitting is stored in the
onboard tool kit and must always remain in the
vehicle. It can be screwed in at the front or rear
of the BMW.

Only use the tow fitting that comes with
the vehicle and screw it in as far as it will

go. Use the tow fitting for towing only on roads.
Avoid lateral loading of the tow fitting, e.g. do
not lift the vehicle by the tow fitting. Otherwise,
damage to the tow fitting and the vehicle can
occur.

<

Access to screw thread

Press the arrow symbol to push out the cover.

Being towed

Do not tow the vehicle by the rear axle;
because there is no steering lock, the

wheels could turn to an extreme angle during
towing. There is no power assist with the
engine stopped. This then requires increased
effort for braking and steering.

<

Switch on the hazard warning flashers depend-
ing on the local regulations. If the electrical sys-
tem fails, mark the vehicle to be towed, e.g. with
a sign or warning triangle in the rear window.

Online Edition for Part No. 01 41 0 012 254 - © 02/06 BMW AG

Advertising
This manual is related to the following products: