Driving, Ignition lock, Starting engine – BMW 645Ci Coupe 2004 User Manual

Page 56

Advertising
background image

Driving

54

Driving

Ignition lock

0 Steering locked

The key can only be inserted or removed in
this position.

After removing the key, turn the steering
wheel slightly until it locks.

Interlock on automatic transmission

>

Only move the selector lever from
position P with the engine running

>

To turn the key back to position 0 or to
remove it, first select the selector lever
position P.

1 Steering unlocked

A slight steering wheel movement often
makes it easier to turn the key from 0 to 1.

Individual current consumers are ready for
operation.

2 Ignition switched on

All vehicle systems are ready for operation.

3 Start engine

Starting engine

Do not run the engine in closed
rooms, as otherwise the inhaling of

toxic exhaust gases can cause uncon-
sciousness and death. The exhaust gases
contain carbon monoxide, an odorless and
colorless, but highly toxic gas.

Never leave an unattended vehicle with the
engine running, as such a vehicle repre-
sents a potential safety hazard.
To prevent the vehicle from rolling, always
select idle position or position N and apply
the handbrake before leaving the vehicle
with the engine running.

<

When starting the engine, do not press the
accelerator pedal.

Do not allow the engine to warm up by
leaving it running while the vehicle remains
stationary. Instead, begin to drive immedi-
ately at a moderate engine speed.

Special starting conditions

Press the accelerator pedal halfway down
when starting if

>

the engine fails to start on the first
attempt, for instance, if it is very hot or
cold

>

the engine is started at very low tem-
peratures, below approx. + 57/–156,
at high altitudes, over 3,300 ft/1,000 m.

Avoid frequent starting in quick suc-
cession or repeated start attempts in

which the engine does not start. Otherwise,
the fuel is not burned or inadequately
burned and there is a danger of overheat-
ing and damaging the catalytic converter.

<

Manual transmission

1.

Apply the handbrake

2.

Gearshift lever in idle position

3.

Press the clutch pedal

If the clutch pedal is not
depressed, the engine will not

start.

<

4.

Start the engine.
Do not terminate the starting operation
too early, but after approx. 20 seconds
at the latest. When the engine starts, let
go of the ignition key immediately.

Online Edition for Part No. 01 41 0 157 980 - © 01/04 BMW AG

Advertising
This manual is related to the following products: