Installing child-restraint systems – BMW X3 3.0i SAV 2004 User Manual

Page 37

Advertising
background image

Reference

At a glance

Controls

Driving tips

Mobility

35

Installing child-restraint
systems

Before installing any child-restraint system
or child seat, read the following:

Observe the child-restraint system
manufacturer's instructions for instal-

lation and use. Otherwise the degree of
protection can be reduced.
After an accident, have all parts of the rele-
vant vehicle safety belt system checked by
a BMW Sports Activity Vehicle Center and
replaced if necessary.

<

Commercially-available

child-restraint sys-

tems are designed to be secured with a lap
belt or with the lap belt portion of a combi-
nation lap/shoulder belt. Improperly or
inadequately installed restraint systems
can increase the risk of injury to children.
Always read and follow the instructions that
come with the system.

Child seat security

All of the rear belt retractors and the front
passenger's safety belt can be locked for
mounting and securing child-restraint sys-
tems.

Information regarding this is located near
the buckle latch of each safety belt.

To lock the safety belt

Pull the entire length of the belt from the
belt retractor. Allow the reel to retract the
belt somewhat and engage the buckle,
then tighten the belt against the child-
restraint system. The retraction mechanism
is now locked.

To unlock the safety belt

Release the buckle, remove the child-
restraint system and allow the belt retractor
to reel the belt completely in.

Child-restraint system with tether
strap

If you use a child-restraint system with a
tether strap, three additional tether anchor-
age points have been provided, refer to the
arrows in the illustration. Depending on the
location selected for seating in the rear
passenger area, attach the tether strap to
the corresponding anchorage point to
secure the child-restraint system, as
shown in the illustration below.

Each seating position is fitted with a head
restraint.

Outer seating positions:
Lift the head restraint and pass the tether
strap between the head restraint and the
seat back. It is recommended to readjust
the head restraint into the lowest possible
position.

Center seating position:
The head restraint must be adjusted into
the lowest possible position. Pass the
tether strap over the head restraint.

Online Edition for Part No. 01 41 0 157 631 - © 07/03 BMW AG

Advertising
This manual is related to the following products: