BMW X3 3.0i SAV 2004 User Manual

Page 103

Advertising
background image

Reference

At a glance

Controls

Driving tips

Mobility

101

4.

Apply the lamp base with the lower
edge to the bracket and press it in until
the lamp base locks in place.

Make sure that the cover does not fall
into the engine compartment, as oth-

erwise the vehicle can be damaged or
other road users can be endangered.

<

Front passenger side

Before replacing the bulb, remove the res-
ervoir for the windshield washing system
from the bracket. To do so, loosen the bolt,
refer to arrow, and place the reservoir to
one side.

Bear in mind that the windshield
washing system reservoir is heavy. If

you do not, injuries or damage to the vehi-
cle can occur.

<

For bulb replacement procedure, refer to
Driver's side.

Xenon lamps*

The service life of these bulbs is very long
and the probability of a failure is very low,
provided that they are not switched on and
off an unusual number of times. If one of
these bulbs should nevertheless fail, it is
possible to continue driving with great cau-
tion using the fog lamps, provided traffic
laws in your area do not prohibit this.

To avoid risk of potentially fatal inju-
ries: owing to the extremely high volt-

ages at which these units operate, service
work should always be entrusted to quali-
fied personnel.

<

Parking and standing lamps

5 Watt bulb

In case of a defect, please contact your
BMW Sports Activity Vehicle Center.

Turn signal indicator, front

21 Watt bulb

Access to the turn signal indicator is at the
edge of the lamp unit, refer to arrow.

Make sure that the lamp base does
not fall into the engine compartment,

as otherwise the vehicle can be damaged
or other road users can be endangered.

<

1.

Turn the lamp base and remove it

2.

Replace the bulb

3.

Insert the lamp base. If it does not snap
in place immediately, turn the lamp
base until it does.

Side-mounted turn signal indicators

5 Watt bulb

1.

Use finger pressure against the rear
end of the lamp, refer to arrow, to press
it forward for removal

2.

Apply gentle pressure to the bulb while
turning it to the left and pull it out

3.

Install in the opposite order.

Online Edition for Part No. 01 41 0 157 631 - © 07/03 BMW AG

Advertising
This manual is related to the following products: