Handbrake, With handbrake set 38, Driving – BMW X3 3.0i SAV 2004 User Manual

Page 40

Advertising
background image

Driving

38

sion control system components, espe-
cially the catalytic converter.

Service Engine Soon indicator lamp
for Canadian models.

Malfunction in the engine electron-
ics.
You can continue to drive with

reduced engine output or engine speed.
Please have it checked by your BMW
Sports Activity Vehicle Center.

Starting the engine

When starting the engine, do not press the
accelerator pedal.

Vehicles with manual transmission:
Step on the clutch when starting the

vehicle. A lockout prevents the engine from
starting if the clutch is not depressed.

<

Do not actuate the starter for too
short a time. Do not turn it for more

than approx. 20 seconds. Release the igni-
tion key immediately as soon as the engine
starts.

<

If the engine fails to start on the first
attempt, for instance, if it is very hot or cold:

>

Press the accelerator pedal halfway
down while engaging the starter.

During a cold start at very low tempera-
tures, as of approx. +5 7/–156, at high
altitudes over 3,300 ft/1,000 m:

>

For the first attempt, run the start for
longer, approx. 10 seconds

>

Press the accelerator pedal halfway
down while engaging the starter.

Avoid frequent starting is quick suc-
cession or repeated start attempts in

which the engine does not start. Otherwise,
the fuel is not burned or inadequately
burned and there is a danger of overheat-
ing and damaging the catalytic converter.

<

Manual transmission

1.

Engage the handbrake

2.

Gearshift lever in idle position

3.

Press the clutch pedal

4.

Start the engine.

Before leaving the vehicle with the
engine running, place the gearshift

lever in idle position and apply the hand-
brake.
Never leave an unattended vehicle with the
engine running, as such a vehicle repre-
sents a potential safety hazard.

<

Automatic transmission

1.

Press the brake pedal

2.

Place the selector lever in position P
or N

3.

Start the engine.

To prevent the vehicle from rolling,
always select position P and engage

the handbrake before leaving the vehicle
with the engine running.
Never leave an unattended vehicle with the
engine running, as such a vehicle repre-
sents a potential safety hazard.

<

Switching off the engine

Do not remove the ignition key when
the vehicle is moving, as otherwise

the steering could lock.
When leaving the vehicle, always remove
the ignition key and lock the steering.
When parking on downward inclines, apply
the handbrake.

<

Manual transmission

Turn the ignition key to position 1 or 0.

Automatic transmission

Engage selector-lever position P, turn igni-
tion key to position 1 or 0.

Handbrake

The handbrake is primarily intended to pre-
vent the vehicle from rolling while parked; it
brakes the rear wheels.

Indicator lamp

The indicator lamp lights up from
ignition switch position 2 with the
handbrake set – an acoustic signal

also sounds when starting off.

Online Edition for Part No. 01 41 0 157 631 - © 07/03 BMW AG

Advertising
This manual is related to the following products: