FORD 2014 Expedition v.3 - Manual (Page 77)

Note: Pressing 5
•6, 7•8, or 9•0 keypad numbers in Step 4 will not
program the code to recall a driver memory setting.
Note: The factory-set code cannot be associated with a memory setting.
Erasing a Personal Code
1. Enter the factory-set 5-digit code.
2. Press and release the 1
•2 on the keypad within five seconds.
The doors will lock and then unlock to confirm that the system is in
programming mode.
3. Press and hold the 1
•2 for two seconds. You must do this within five
seconds of completing Step 2.
All personal codes are now erased and only the factory-set 5-digit code
will work.
Anti-Scan Feature
The keypad will go into an anti-scan mode if you enter the wrong code
seven times (35 consecutive button presses). This mode disables the
keypad for one minute and the keypad lamp will flash.
The anti-scan feature will turn off after:
• one minute of keypad inactivity
• pressing the unlock button on the remote control
• the ignition is turned on.
Unlocking and Locking the Doors and Liftgate
To unlock the driver door: Enter the factory-set 5-digit code or your
personal code. You must press each number within five seconds of each
other. The interior lamps will illuminate.
To unlock all doors and liftgate: Enter the factory-set 5-digit code or
your personal code, then press 3
•4 within five seconds.
To lock all doors and liftgate: Press and hold 7
•8 and 9•0 at the
same time with the driver door closed. You do not need to enter the
keypad code first.
To open the liftgate glass: Enter the factory-set 5-digit code or your
personal code, then press 5
•6.
76 Locks
2014 Expedition (exd)
Owners Guide gf, 3rd Printing, March 2014
USA (fus)