Driving the vehicle -11, Continuously variable transmission (cvt), If so equipped) -11 – NISSAN 2009 Altima Coupe - Owner's Manual User Manual

Page 249

Advertising
background image

4. Warm-up

Allow the engine to idle for at least 30 sec-

onds after starting. Do not race the engine

while warming it up. Drive at moderate

speed for a short distance first, especially in

cold weather. In cold weather, keep the en-

gine running for a minimum of 2 - 3 minutes

before shutting it off. Starting and stopping

the engine over a short period of time may

make the vehicle more difficult to start.

5. To stop the engine, shift the selector to the P

(Park) position (CVT) or to N (Neutral) and

apply the parking brake (MT) and push the

ignition switch to the OFF position.

CONTINUOUSLY VARIABLE

TRANSMISSION (CVT) (if so

equipped)

WARNING

Do not depress the accelerator pedal

while shifting from P (Park) or N (Neu-

tral) to R (Reverse), D (Drive) or manual

shift mode. Always depress the brake

pedal until shifting is completed. Fail-

ure to do so could cause you to lose

control and have an accident.

Cold engine idle speed is high, so use

caution when shifting into a forward or

reverse gear before the engine has

warmed up.

Do not downshift abruptly on slippery

roads. This may cause a loss of control.

Never shift to P (Park) or R (Reverse)

while the vehicle is moving. This could

cause an accident.

CAUTION

When stopping the vehicle on an uphill

grade, do not hold the vehicle by depress-

ing the accelerator pedal. The foot brake

should be used for this purpose.

The CVT in your vehicle is electronically con-

trolled to produce maximum power and smooth

operation.
The recommended operating procedures for this

transmission are shown on the following pages.

Follow these procedures for maximum vehicle

performance and driving enjoyment.

NOTE:
Engine power may be automatically re-

duced to protect the CVT if the engine

speed increases quickly when driving on

slippery roads or while being tested on

some dynamometers.

Starting the vehicle

1. After starting the engine, fully depress the

foot brake pedal before moving the shift

selector out of the P (Park) position.

2. Keep the foot brake pedal depressed and

move the shift selector into a driving gear.

3. Release the foot brake, then gradually start

the vehicle in motion.

4. Stop the vehicle completely before placing

the shift selector in the P (Park) position.

DRIVING THE VEHICLE

Starting and driving

5-11

REVIEW COPY—

2009 Altima (alt)

Owners Manual (owners)—USA_English (nna)
02/03/09—debbie

Advertising