NISSAN 2010 Altima Hybrid - Quick Reference Guide - Manual (Page 19)

PROGRAMMinG yOuR HOMeLink ® uniVeRSAL TRAnSceiVeR
(Mirror, Sun Visor or Overhead console)
1. To begin, press and hold the two outer
HomeLink
® buttons (to clear the
memory) until the indicator light blinks
slowly (after 20 seconds). Release
both buttons.
2. Position the end of the hand-held
transmitter 1-3 in (26-76 mm) away
from the HomeLink
® surface.
3. using both hands, simultaneously press and hold both the HomeLink ® button you want to
program and the hand-held transmitter button. DO NOT release the buttons until step 4
has been completed.
4. Hold down both buttons until the indicator light on the HomeLink
® flashes, changing from
a “slow blink” to a “rapidly flashing blink.” This could take up to 90 seconds. When the indicator
light flashes rapidly, both buttons may be released. The rapidly flashing light indicates
successful programming. To activate the garage door or other programmed device, press
and hold the programmed HomeLink
® button - releasing when the device begins to activate.
5. if the indicator light on the HomeLink ® blinks rapidly for 2 seconds and then turns solid,
HomeLink ® has picked up a “rolling code” garage door opener signal. you will need to
proceed with the next steps to train the HomeLink ® to complete the programming, which
may require a ladder and another person for convenience.
6. Press and release the “smart” or “learn” program button located on the garage door opener’s
motor to activate the “training mode.” This button is usually located near the antenna wire that
hangs down from the motor. if the wire originates from under a light lens, you will need to
remove the lens to access the program button.
NOTE: Once you have pressed and released the program button on the garage door
opener’s motor and the “training light” is lit, you have 30 seconds in which to perform
step 7. Use the help of a second person for convenience to assist when performing this step.
7. Within 30 seconds of pressing and releasing the garage door opener program button, firmly
press and release the HomeLink
® button you’ve just programmed. Press and release the
HomeLink ® button up to 3 times to complete the training.
8. your HomeLink ® button should now be programmed. (To program the remaining HomeLink ®
buttons for additional door or gate openers, follow steps 2-8 only.)
BLUETOOTH ® HANDS-FREE PHONE SYSTEM
(vehicles with navigation)
With an overhead microphone and sound
transmitted through the audio system speakers,
the Bluetooth
® Hands-free Phone System utilizes
Bluetooth ® wireless technology, a touch-screen
and voice recognition to provide hands-free
cellular phone communication.
17