NISSAN 2013 Frontier - Owner's Manual - Manual (Page 72)

Refer to all Warnings and Cautions in the “Child
Safety” and “Child Restraint” sections before in-
stalling a child restraint.
Follow these steps to install a forward-facing
child restraint using the vehicle seat belt in the
passenger’s side jump seat (King cab models
only) or in the front passenger seat:
1. If you must install a child restraint in
the front seat, it should be placed in a
forward-facing direction only. Move
the seat to the rearmost position. Child
restraints for infants must be used in
the rear-facing direction and therefore
must not be used in the front seat.
2. To access the jump seat extension (passen-
ger’s side only)
᭺
1 on the jump seat, pull up
᭺
2 on the extension to unfold it to the open
position. Then unfold the two support legs
᭺
3 and lower the jump seat to the full open
᭺
4 seating position.
3. Position the child restraint on the seat. Al-
ways follow the child restraint manufactur-
er’s instructions.
The back of the child restraint should be
secured against the vehicle seat back.
If necessary, adjust or remove the head re-
straint to obtain the correct child restraint fit.
If the head restraint is removed, store it in a
secure place. Be sure to reinstall the
head restraint when the child restraint
is removed. See “Head restraints” in this
section for head restraint adjustment, re-
moval and installation information.
LRS0559 LRS0537
Forward-facing — step 3
WRS0919
Safety—Seats, seat belts and supplemental restraint system 1-53