NISSAN 2011 GT R - Owner's Manual - Manual (Page 204)

Black plate (202,1)
Model "R35-D" EDITED: 2009/ 12/ 11
The control of the dual clutch transmission,
Bilstein DampTronic
®
electronically controlled
shock absorbers and Vehicle Dynamic Control
(VDC) can be changed to the desired modes by
operating the setup switches. Select the desired
mode best suited to the driving conditions.
NOTE:
Bilstein DampTronic
®
is a registered trade-
mark of ThyssenKrupp Bilstein Suspen-
sion GmbH.
1. Transmission setup switch
2. Suspension setup switch
3. Vehicle Dynamic Control (VDC) setup switch
HOW TO SWITCH THE MODES
Move the VDC, transmission and suspension
setup switches up or down to change the mode
when the engine is running.
R mode
Push up the VDC, transmission and suspension
setup switches for more than 1 second.
SNOW mode and COMF mode
Push down the transmission and suspension
setup switches.
VDC OFF mode
Push down the VDC setup switch for more than
1 second.
Normal mode
Push the VDC, transmission and suspension
setup switches to the side opposite from the
selected modes.
NOTE:
. When the ignition switch is pushed to
the ON position, the VDC, transmission
and suspension set up switch indica-
tors may come on momentarily, but this
does not indicate that there is a mal-
function.
. The VDC, transmission and suspension
setup switches will return to the normal
mode when the engine is restarted.
5-22 Starting and driving
VDC, TRANSMISSION AND
SUSPENSION SETUP SWITCHES