NISSAN 2011 GT R - Multi Function Display Owner's Manual - Manual (Page 271)

Black plate (277,1)
Model "R35-N" EDITED: 2009/ 10/ 30
&
3 SPEED:
Displays the vehicle speed while driving.
&
4 ELAPSED TIME:
Displays the total elapsed time measured
since the stopwatch function was started.
Measuring timed distance
To measure the timed distance, use <START/
STOP> or <MRK> on the steering switch.
1. With the STOP WATCH screen displayed,
push <START/STOP>. The timer-on in-
dicator will flash when the stopwatch func-
tion is active.
2. Each time you push <MRK> the displayed
time will be recorded into the system and
will be viewable in the list.
3. Push <START/STOP>. The stopwatch
function will stop timing.
INFO:
. The STOP WATCH function can only be
used when the clock is activated.
. If using the driver’s notes, the STOP
WATCH function is unavailable. To use the
STOP WATCH function, first finish using the
driver’s notes.
. If the ignition is in the OFF position, you will
not be able to use the STOP WATCH
function.
. If the ignition is put into the ACC or the OFF
position while using the timer, timing will
end.
. The timer will continue timing while you
display other screens until you push
<START/STOP>.
. The maximum time that the system timer can
display is a recorded time of up to 9 hours
59 minutes and 59.99 seconds.
. When timing has finished, the upper timer
will reset to 00:00.0
. When the recorded time and the finished
recording time are displayed, they tempora-
rily interrupt the time recorder display and
are displayed in large numbers. The re-
corded time will disappear automatically
after 5-10 seconds.
. When screens other than the multi function
meter are displayed, the STOP WATCH
screen will not interrupt the display.
Multi function meter 9-29