NISSAN 2014 GT R - Service & Maintenance Guide - Manual (Page 8)

GT-R Performance Optimization Services
In addition to the regular maintenance recommended by NISSAN, the GT-R requires the following Inspections;
Measurement and adjustment of wheel alignment if needed (unladen with fuel and lubricants full,
including tire pressure adjustment) Note 1
● Note 1: This vehicle is equipped with a high performance suspension. As the suspension components
Љbreak-inЉ, the vehicle’s wheel alignment needs to be measured and adjusted by a GT-R certified dealer at the
recommended intervals.
Preventing Toe-Out: Toe-out can cause uneven tire wear or damage to areas inside the tires due to high heat.
Be sure to have the wheel alignment toe-in setting checked and adjusted by your GT-R certified NISSAN
dealer before any performance driving on closed circuit tracks. Obey all traffic laws when on public roads.
Toe-in specification for each wheel
Front: 0.059 in (1.5 mm)
Rear: 0.079 in (2.0 mm)
Engine settings (balancing of air flow for left and right banks) Note 2
● Note 2: Each cylinder bank of this engine operates independently due to the vehicle’s twin turbocharger
design. Each side of the engine must operate at the same level of performance. The air flow of each bank
must be checked and adjusted as necessary by a GT-R certified NISSAN dealer.
Transmission settings Note 3
● Note 3: The design of the clutch and transmission requires inspection and adjustment of the clutch and shift
forks by a GT-R certified NISSAN dealer at the recommended intervals. If the transmission setting is not
complete, excessive loads may be applied to the transmission and power train system parts during starting
and shifting, which may result in a malfunction or damage.
NISSAN MAINTENANCE
7