NISSAN 2014 GT R - Multi Function Display Owner's Manual - Manual (Page 140)

Adjusting tone quality and speaker bal-
ance:
To adjust Bass, Treble, Balance and Fade, push
the Audio control knob. When the display shows
the setting you want to change (Bass, Treble,
Balance and Fade), rotate the Audio control
knob to set the desired setting.
“Audio settings” (page 7-3)
Switching the display:
Pushing <DISC·AUX> will switch the displays
as follows:
iPod ® /USB ? CD/DVD ? Bluetooth ® stream-
ing audio
? AUX (if so equipped) ? iPod ® /
USB
FM-AM-SAT radio operation
FM/AM radio band select:
Pushing <FM·AM> will change the band as
follows:
AM ? FM1 ? FM2 ? AM
SiriusXM Satellite Radio band select:
Pushing <SAT> will change the band as
follows:
XM1
? XM2 ? XM3 ? XM1
When <FM·AM> or <SAT> is pushed while
the ignition switch is in the ACC or ON position,
the radio will come on at the channel last played.
The last channel played will also come on when
the ON·OFF button is pushed to ON.
The satellite radio is not available in Alaska,
Hawaii and Guam.
If another audio source is playing when
<FM·AM> or <SAT> is turned to ON, the
audio source will automatically be turned off and
the last radio channel played will come on.
When the stereo broadcast signal is weak, the
radio will automatically change from stereo to
monaural reception.
TUNE (Tuning):
. For AM and FM radio
Turn the radio TUNE knob for manual tuning.
. For SiriusXM Satellite Radio
Turn the radio TUNE knob to seek channels
from all of the categories when any category
is not selected.
SEEK tuning/CATEGORY (CAT):
. For AM and FM radio
Push < > or < > to tune from low to
high or high to low frequencies and to stop
at the next broadcasting station.
. For SiriusXM Satellite Radio
Push < > or < > to tune to the first
channel of the next or previous category.
During satellite radio reception, the following
notices will be displayed under certain condi-
tions.
. NO SIGNAL (No signal is received while the
SAT tuner is connected.)
. OFF AIR (Broadcasting signed off)
. CHECK ANTENNA (Antenna connection
error)
. LOADING (When the initial setting is
performed)
Audio system 3-13