Essential information, Clock set/adjustment – NISSAN 2015 LEAF - Quick Reference Guide User Manual

Page 13

Advertising
background image

To view detailed instructional videos regarding these and other features,

please go to www.nissanownersinfo.mobi.

10

TIRE PRESSURE MONITORING SYSTEM (TPMS)

WITH EASY FILL TIRE ALERT

A CHECK TIRE PRESSURE warning message

will appear in the vehicle information display

1

and the low tire pressure warning light

2

will illuminate when one or more tires are low in

pressure and air is needed.

When adding air to an under-inflated tire, the

TPMS with Easy Fill Tire Alert system provides visual and audible signals

to help you inflate the tires to the recommended COLD tire pressure.

To use the Easy Fill Tire Alert system:

1. Apply the parking brake and press the P (PARK) button on the shift lever.

2. Place the power switch in the ON position. Do not place in the READY to drive mode.

3. Add air to the underinflated tire, and within a few seconds the hazard warning lights

will flash.

4. When the designated tire pressure is reached, the horn will beep once and the

hazard warning message lights will stop flashing.

5. Repeat this procedure for any additional underinflated tires.
After tire pressures are adjusted, drive the vehicle at speeds above 16 mph (25 km/h)

and the warning and indicator light will extinguish.

When the low tire pressure warning light flashes for approximately 1 minute and then

remains on, the TPMS is not functioning properly. Have the system checked by a

NISSAN-certified LEAF dealer.

Tire pressure rises and falls depending on the heat caused by the vehicle’s operation

and the outside temperature. Low outside temperature can lower the temperature of the

air inside the tire, which can cause a lower tire inflation pressure. This may cause the

low tire pressure warning light to illuminate. If the warning light illuminates, check the tire

pressure in your tires.

For more information, refer to the “Instruments and controls (section 2)” and the “Starting and driving (section
5)”
of your Owner’s Manual.

CLOCK SET/ADJUSTMENT

To adjust the instrument panel clock

1

, use the

Settings menu in the vehicle information display.

The Settings menu

2

is accessed by pressing

the button

3

on the left side of the

instrument panel.

Press the button

4

to cycle through the

various Settings modes.

This clock is linked to the GPS (if so equipped)

through the center display clock.

• Without any adjustments, the correct time will be

displayed based on the vehicle’s current location.

• There are also controls in the center display to

compensate for daylight savings time.

For more information, refer to the “Instruments and controls
(section 2)”
of your Owner’s Manual.

4

3

2

1

ESSENTIAL INFORMATION

1

2

1789594_15b_Leaf_QRG_063014.indd 10

6/30/14 1:29 PM

Advertising