Accessory mode, Nissan intelligent key™ battery discharge, Opening the trunk – NISSAN 2009 Maxima - Quick Reference Guide User Manual

Page 5: Automatic door locks

Advertising
background image

ACCESSORY MODE

Ⅲ Press the START/STOP button once without depressing the brake pedal to access the

ACC mode. This position activates electrical accessories such as the radio.

Ⅲ Press the ignition switch START/STOP button a second time to ON without depressing

the brake pedal. This position turns on the ignition switch and all electrical accessories.

NISSAN INTELLIGENT KEY™ BATTERY DISCHARGE

Ⅲ If the battery of the Intelligent Key is almost discharged,

the guide light of the Intelligent Key port blinks and the
Intelligent Key insertion indicator is displayed in the
vehicle information display.

Ⅲ To start the engine under these circumstances, insert

the Intelligent Key into the key port in the direction
indicated until it latches into place.

Ⅲ To remove the Intelligent Key from the port, push the

ignition switch to turn the engine off and pull the Intelligent Key out of the port.

Ⅲ The Intelligent Key port does not charge the Intelligent Key battery. If you see the low

battery indicator, replace the battery in the Intelligent Key.

OPENING THE TRUNK

Ⅲ To open the trunk using the request switch, your Intelligent

Key must be with you.

Ⅲ Push the Request/Release switch

under the trunk

handle.

Ⅲ Lift up on the trunk lid to fully open the trunk.

AUTOMATIC DOOR LOCKS

Ⅲ All doors lock automatically when the vehicle speed reaches 15 MPH (24 km/h).
Ⅲ All doors unlock automatically when the ignition is placed in the OFF position.

The automatic lock and unlock functions can be deactivated or activated inde-
pendently of each other.
To deactivate or activate the automatic door lock or unlock
system, perform the following procedure:

1. Close all doors.

2. Place the ignition switch in the ON position.

3. Do one of the following within 20 seconds of performing Step #2:

● To change AUTO UNLOCK settings: push and hold the power door lock switch to

the

position (UNLOCK) for more than 5 seconds.

● To change AUTO LOCK settings: push and hold the power door lock switch to

the

position (LOCK) for more than 5 seconds.

3

Advertising