NISSAN 2013 Maxima - Quick Reference Guide - Manual (Page 8)

To view detailed instructional videos regarding these and other features, please go to www.nissanownersinfo.mobi
AUTOMATIC DRIVE POSITIONER (if so equipped)
Two positions for the driver’s seat, steering column
and outside mirrors can be stored in the automatic
drive positioner memory.
Follow these procedures to set the memory positions:
• Confirm the shift lever is in the P (Park) position.
• Push the ignition switch to the on position.
• Adjust the driver’s seat, steering column and outside mirrors to the desired positions using
the adjusting switches for each feature.
• Push the sEt switch within 5 seconds push the memory switch (1 or 2) for at least
1 second.
• The indicator light on the memory switch you select will illuminate for approximately
5 seconds.
• The driver’s seat, steering column and outside mirror positions are now set to your preference.
These memorized positions can also be linked to your NISSAN Intelligent key
® .
For more information, refer to the “Pre-driving checks and adjustments (section 3)” of your Owner’s Manual.
outsiDE mirror Control sWitCh
The outside mirror control switch is located on the
left side of the instrument panel.
To select the left or right mirror, move the switch
01
.
Adjust each mirror to the desired position using the
switch
02
.
To prevent accidentally moving the mirror, move this
switch
01
to the center “neutral” position.
REVERSE TILT-DOWN FEATURE (if so equipped)
When the small switch
01
is in either the left or right position, the reverse tilt-down feature
will turn both outside mirror surfaces downward to provide better rear visibility close to the
vehicle.
To turn both mirrors downward, move the shift selector to r (rEvErsE).
NOTE: If the small switch is in the “neutral” position, neither mirror will turn downward when the
shift selector is moved to r (rEvErsE).
The mirror surfaces will return to their original position when any of the following have occurred:
• The shift selector is moved to any position other than r (rEvErsE).
• The outside mirror control switch is set to the center “neutral” position.
• The ignition switch is placed in the off position.
For more information, refer to the “Pre-driving checks and adjustments (section 3)” of your Owner’s Manual.
6
first drive features
01
02
1351487_13b_Maxima_QRG_010813b.indd 6 1/8/13 2:12 PM