NISSAN 2012 Murano - Quick Reference Guide - Manual (Page 13)

11
To view detailed instructional videos regarding these and other features,
please go to www.nissanownersinfo.mobi.
To slide the front passenger’s seat back into position,
push the bottom half of the seatback
05
until it
locks. Next, adjust the seatback by pulling the
seatback lever
06
up. Release the lever to lock
the seatback into position.
For more information, refer to the “Safety – Seats, seat belts and
supplemental restraint system (section 1)” of your Owner’s Manual.
01
03
02
STarTING/STOPPING THe eNGINe
Depress the brake pedal.
Press the ignition switch STarT/STOP button to
start the engine.
NOTE: It is important to make sure the NISSAN Intelligent
key
® is with you (that is, in your pocket or purse).
TURNING THE ENGINE OFF
Move the shift lever to the P (Park) position and
apply the parking brake.
Press the ignition switch STarT/STOP button to turn the engine off.
EMERGENcY ENGINE SHUT OFF
To shut off the engine in an emergency situation while driving, perform one of the following procedures:
Rapidly push the push button ignition switch 3 consecutive times in less than 1.5 seconds, or
Push and hold the push button ignition switch for more than 2 seconds.
For more information, refer to the “Starting and driving (section 5)” of your Owner’s Manual.
HeaDLIGHT CONTrOL SwITCH
HEADLIGHT cONTROL
Turn the headlight control switch to the
position 01
to turn on the front parking, side
marker, tail, license plate and instrument panel
lights. Turn the switch to the position
02
to
turn on the headlights.
AUTOLIGHT SYSTEM (if so equipped)
The autolight system will automatically turn the headlights on when it is dark and off when it
is light. The system will keep the headlights on for a period of time after you turn the ignition
off and all doors are closed.
To activate the autolight system, turn the headlight control switch to the auTO position
03
then push the ignition switch to ON. To deactivate the autolight system, turn the headlight
control switch to the OFF, 01
or position 02
.
HIGH BEAM SELEcT
Push the headlight control switch forward
04
to
select the high beam function. The blue indicator
light illuminates in the instrument panel. Pull
the headlight switch back to the original position to
select the low beam. The blue indicator light goes off.
Pull and release the headlight control switch
05
to
flash the headlight high beams on and off.
04
05