What gets restored, and to where – Clickfree iPod Transformer User Manual

Page 26

Advertising
background image

Clickfree iPod Transformer User Guide

Restoring my content

Copyright © 2009 Storage Appliance Corporation.

26

W

HAT GETS RESTORED

,

AND TO WHERE

?

When

Clickfree

restore runs without you changing any options, it restores all of the

content that was backed up, and puts it in the same folders on your computer that it was
backed up from. This is the best choice if you have a new computer, or if you have repaired
your old computer and all of the content was erased.

For details, see:

• “How do I let Clickfree restore decide what to restore and where?” on page 26

On the other hand, if you have files on the computer you are restoring to, the restored files
replace files of the same name in the same location, but only after asking your permission.

If you prefer, you can easily tell

Clickfree

to restore your files to a place on your

computer’s hard drive where they will not replace the files you already have.

For details, see:

• “How do I change how Clickfree restores content?” on page 31.

H

OW DO

I

LET

C

LICKFREE RESTORE DECIDE WHAT TO RESTORE AND WHERE

?

You can allow Clickfree to make the decisions about what to restore and to where, but you
need to confirm what Clickfree plans to do.

To let

Clickfree

decide what to restore and to where:

1. Make sure that your computer is switched on and has finished starting up.

2. Log in, if that is what you normally do.

3. Connect the

Clickfree

iPod Transformer to your computer by plugging it in to a USB

port.

Clickfree

starts up just as it did when you used it to back up your content.

4. Wait for the

Clickfree

window to appear – this may take up to 60 seconds.

5. Connect your iPod to the

Clickfree

iPod Transformer.

The

Clickfree

Welcome

window appears with the countdown, just as it did when you

used it to back up your content.

But this time you are not going to allow

Clickfree

to start the backup.

Advertising