NISSAN 2012 Pathfinder - Owner's Manual User Manual

Page 462

Advertising
background image

WARNING

Properly adjust the weight distributing
hitch so the rear of the bumper is no
higher

than

the

measured

reference

height when the trailer is attached. If the
rear bumper is higher than the measured
reference height when loaded, the vehicle
may handle unpredictably which could
cause a loss of vehicle control and cause
serious

personal

injury

or

property

damage.

Sway control device

Sudden maneuvers, wind gusts, and buffeting
caused by other vehicles can affect trailer han-
dling. Sway control devices may be used to help
control these affects. If you choose to use one,
contact a reputable trailer hitch supplier to make
sure the sway control device will work with the
vehicle, hitch, trailer and the trailer’s brake sys-
tem. Follow the instructions provided by the
manufacturer for installing and using the sway
control device.

Class I hitch

Class I trailer hitch equipment (receiver, ball
mount and hitch ball) can be used to tow trailers
of a maximum weight of 2,000 lb (907 kg).

Class II hitch

Class II trailer hitch equipment (receiver, ball
mount and hitch ball) can be used to tow trailers
of a maximum weight of 3,500 lb (1,587 kg).

Class III hitch

Class III trailer hitch equipment (receiver, ball
mount and hitch ball) can be used to tow trailers
of a maximum weight of 5,000 lb (2,268 kg).

Class IV hitch

Class IV trailer hitch equipment (receiver, ball
mount and hitch ball) can be used to tow trailers
of a maximum weight of 10,000 lb (4,535 kg). A
weight distributing hitch should be used to tow
trailers that weigh over 5,000 lb (2,268 kg).

Your vehicle may be equipped with Class IV
trailer hitch equipment that has a 10,000 lb
(4,535 kg) maximum weight rating, but your ve-
hicle is only capable of towing the maximum
trailer

weights

shown

in

the

“Towing

Load/Specification” chart earlier in this section.

CAUTION

Special hitches which include frame re-

inforcements are required for towing
above 2,000 lb (907 kg). Suitable genu-
ine NISSAN hitches, ball mounts and
hitch balls for pickup trucks and sport
utility

vehicles

are

available

at

a

NISSAN dealer.

The hitch should not be attached to or

affect the operation of the impact-
absorbing bumper.

Do not use axle-mounted hitches.
Do not modify the vehicle exhaust sys-

tem, brake system, etc. to install a
trailer hitch.

To reduce the possibility of additional

damage if your vehicle is struck from
the rear, where practical, remove the
receiver when not in use.

Regularly check that all trailer hitch

mounting bolts are securely mounted.

Technical and consumer information

9-23

Advertising
This manual is related to the following products: