NISSAN 2015 Pathfinder - Quick Reference Guide - Manual (Page 32)

To view detailed instructional videos regarding these and other features,
please go to www.nissanownersinfo.mobi. 30
HOMELINK ® UNIVERSAL TRANSCEIVER (if so equipped)
The HomeLink ® Universal Transceiver system can
learn and consolidate the functions of up to 3
different hand-held transmitters, operating items
such as garage doors, property gates, outdoor
and indoor lights or alarm systems.
To program the HomeLink ® Universal Transceiver:
• Position the handheld transceiver 1-3 in (26-76
mm) away from the HomeLink surface, keeping
the HomeLink indicator light in view.
• Press and hold the desired HomeLink button and the handheld transmitter button
simultaneously until the HomeLink indicator light flashes slowly and then rapidly.
• Both buttons may be released when the indicator light flashes rapidly.
To verify the programing is complete, press and hold the HomeLink button and observe
the indicator light:
• A solid, continuous light indicates the programing is complete and the HomeLink
button will activate your device.
• A blinking light that turns to a solid, continuous light after 2 seconds indicates
additional steps are required to complete the programing.
An additional person may make the remaining steps easier. To complete the
programing process:
• At the receiver of the device that you are programing to the HomeLink button, press
and release the learn or smart button (the name may vary by manufacturer, but it is
usually located near where the hanging antenna wire is attached to the unit). You have
approximately 30 seconds to initiate the following step.
• Press and hold the programed HomeLink button for 2 seconds and release.
You may have to repeat the previous two steps up to 3 times to complete the
programing process. HomeLink should now activate your device.
For more information, refer to the “Instruments and controls (section 2)” of your Owner’s Manual, the HomeLink website at
www.homelink.com or call 1-800-355-3515.
HOMELINK
SYSTEM GUIDE
To watch or control videos on the front display, make sure the vehicle is in the P
(PARK) position and the parking brake is applied.
To reduce driver distraction, the wireless headphones will not operate while located in
the front seats and movies will not be shown on the front display while the vehicle is in
any drive position.
To access standard DVD controls on the front display while playing a DVD on the rear
display, press the DISC•AUX button on the audio control panel while the vehicle is in
the P (PARK) position and the parking brake is applied.
For more information, refer to the “Monitor, climate, audio, phone and voice recognition systems (section 4)” of
your Owner’s Manual.
1758976_15b_Pathfinder_QRG_091014.indd 30 9/10/14 12:08 PM