NISSAN 2014 Quest - Owner's Manual - Manual (Page 290)

SAA0978
Remote controller
SAA3611
Headphones
Remote controller and headphones bat-
tery replacement
Replace the battery as follows:
1. Open the lid.
The lid is easy to open if a flat head
screwdriver etc., is used.
2. Replace both batteries with new ones.
. Size AA (remote control)
. Size AAA (headphones)
Make sure that the
+ and 7 ends on
the batteries match the markings in-
side the compartment.
3. Close the lid securely.
If the battery is removed for any reason
other than replacement, close the lid
securely.
. If you will not be using the remote control
for long periods of time, remove the
batteries.
. Replacement of the batteries is needed
when the remote control only functions at
extremely close distances to the MES or
not at all.
. Be careful not to touch the battery
terminal.
. An improperly disposed battery can harm
the environment. Always confirm local
regulations for battery disposal.
. When changing batteries, do not let dust
or oil get on the remote control and
headphones.
FCC Notice:
For USA:
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any interfer-
ence received, including interference that
may cause undesired operation.
Note: Changes or modifications not ex-
pressly approved by the party responsible
for compliance could void the user’s
authority to operate the equipment.
For Canada:
This device complies with RSS-210 of
Industry Canada. Operation is subject to
the following two conditions: (1) this
device may not cause interference, and
(2) this device must accept any interfer-
ence, including interference that may
cause undesired operation of the device.
Monitor, heater, air conditioner, audio, phone and voice recognition systems 4-107