NISSAN 2012 Sentra - Owner's Manual User Manual

Page 87

Advertising
background image

ENGINE OIL PRESSURE GAUGE (if
so equipped)

The gauge indicates the engine lubrication sys-
tem oil pressure while the engine is running.
When the engine speed is high, the engine oil
pressure is also high. When the engine speed is
low, the gauge indicates lower oil pressure.

Engine oil pressure also changes based on en-
gine temperature. The oil pressure will be higher
when the engine is cold and lower when the
engine is warm.

CAUTION

This gauge is not designed to indicate

low engine oil level. Use the dipstick to
check the oil level. (See “Engine oil” in
the “Maintenance and do-it-yourself”
section.)

If the gauge needle does not move with

the proper amount of engine oil, have
the vehicle checked by a NISSAN
dealer. Continued vehicle operation in
such a condition could cause serious
damage to the engine.

TRIP COMPUTER (if so equipped)

When the ignition switch is placed in the ON
position, modes of the trip computer can be
selected by pushing the trip computer change
button on the instrument panel located near the
speedometer. The following modes can be se-
lected in the display:

● Distance to empty
● Instant fuel economy
● Average fuel consumption
● Average speed
● Journey time

Distance to empty (dte—mile or km)

The distance to empty (dte) mode provides you
with an estimation of the distance that can be
driven before refueling. The dte is constantly be-
ing calculated, based on the amount of fuel in the
fuel tank and the actual fuel consumption.

The display is updated every 30 seconds.

NOTE:

When driving uphill or rounding curves, the
fuel in the tank shifts, which may momen-
tarily change the display.

Instant fuel economy

The instant fuel economy mode shows the instant
fuel consumption. The display updates instantly
when driving.

Average fuel consumption (Mpg or
l/100km)

The average fuel consumption mode shows the
average fuel consumption since the last reset.
Resetting is done by pressing the change button
for more than approximately 1 second. The dis-
play is updated every 30 seconds. At about the
first 1/3 miles (500 m) after a reset, the display
shows (----).

LIC1114

2-8

Instruments and controls

Advertising