NISSAN 2011 Titan - Owner's Manual - Manual (Page 136)

PROGRAMMING HOMELINK
ா
1. To begin, press and hold the two outer
HomeLink
ா buttons (to clear the memory)
until the indicator light
᭺
1 blinks (after 20
seconds). Release both buttons.
2. Position the end of the hand-held transmitter
1 - 3 inches (26 - 76 mm) away from the
HomeLink
ா surface.
3. Using both hands, simultaneously press and
hold both the HomeLink
ா button you want to
program and the hand-held transmitter but-
ton.
DO NOT release the buttons until step 4 has
been completed.
4. Hold down both buttons until the indicator
light on the HomeLink ா flashes, changing
from a “slow blink” to a “rapidly flashing
blink”. This could take up to 90 seconds.
When the indicator light flashes rapidly, both
buttons may be released. The rapidly flash-
ing light indicates successful programming.
To activate the garage door or other pro-
grammed device, press and hold the pro-
grammed HomeLink
ா button — releasing
when the device begins to activate.
5. If the indicator light on the HomeLink
ா blinks
rapidly for 2 seconds and then turns solid,
HomeLink
ா has picked up a “rolling code”
garage door opener signal. You will need to
proceed with the next steps to train the
HomeLink
ா to complete the programming
which may require a ladder and another per-
son for convenience.
6. Press and release the “smart” or “learn” pro-
gram button located on the garage door
opener’s motor to activate the “training
mode”. This button is usually located near
the antenna wire that hangs down from the
motor. If the wire originates from under a
light lens, you will need to remove the lens to
access the program button.
NOTE:
Once you have pressed and released the
program button on the garage door open-
er’s motor and the “training light” is lit, you
have 30 seconds in which to perform step 7.
Use the help of a second person for conve-
nience to assist when performing this step.
WIC0986 WIC0987
Instruments and controls 2-57