NISSAN 2013 Versa Sedan - Owner's Manual - Manual (Page 127)

1. Pull the hood lock release handle
᭺
1 located
below the instrument panel until the hood
springs up slightly.
2. Locate the lever
᭺
2 in between the hood and
grille and push the lever sideways with your
fingertips.
3. Raise the hood
᭺
3 .
4. Remove the support rod
᭺
4 and insert it into
the slot
᭺
5 .
Hold the coated parts when removing or
resetting the support rod. Avoid direct con-
tact with the metal parts, as they may be
hot immediately after the engine has been
stopped.
When closing the hood, return the support rod to
its original position, lower the hood to approxi-
mately 12 in (30 cm) above the latch and release
it. This allows proper engagement of the hood
latch.
WARNING
● Make sure the hood is completely
closed and latched before driving. Fail-
ure to do so could cause the hood to fly
open and result in an accident.
● If you see steam or smoke coming from
the engine compartment, to avoid injury
do not open the hood.
LPD2035
HOOD
3-24 Pre-driving checks and adjustments