NISSAN 2013 Versa Sedan - Owner's Manual - Manual (Page 25)

Install (if so equipped)
1. Align the head restraint stalks with the holes
in the seat. Make sure the head restraint is
facing the correct direction. The stalk with
the adjustment notches
᭺
1 must be installed
in the hole with the lock knob
᭺
2 .
2. Push and hold the lock knob and push the
head restraint down.
3. Properly adjust the head restraint before an
occupant uses the seating position.
REMOVABLE HEAD RESTRAINT
WARNING
The removable head restraints supple-
ment the other vehicle safety systems.
They may provide additional protection
against injury in certain rear end colli-
sions. Do not attach anything to the re-
movable head restraint stalks or remove
the head restraint unless it is required
when the rear seat is folded down. Do not
use the seat if the head restraints have
been removed. If the head restraint was
removed, reinstall it before an occupant
uses the seating position. Failure to fol-
low these instructions can reduce the ef-
fectiveness of the removable head re-
straint. This may increase the risk of
serious injury or death in a collision.
The illustration shows the seating positions
equipped with removable head restraints.
᭡ Indicates the seating position is equipped with
a head restraint.
+ Indicates the seating position is not equipped
with a head restraint or removable headrest.
LRS0891 LRS2000
1-8 Safety—Seats, seat belts and supplemental restraint system