Gamo Green Laser and Light - Manual (Page 5)

5. ADJUSTING THE LASER WINDAGE AND ELEVATION
The elevation and windage adjustment screws are
located in front of the laser beam protective housing.
When the Elevation adjustment screw is turned
counter clockwise, the laser dot will move “up”
and when it is turned clockwise the laser dot will
move “down”.
The windage adjustment screw is located to the side
of the elevation adjustment. When turned counter-
clockwise, the laser dot will move to the “right”. When
turned clockwise the laser dot will move to the “left”.
6. REPLACING THE LASER OR LED LIGHT SWITCHES
Remove the push button assembly from the back of the LED Light by rotating it
counterclockwise until loose. Install the new switch by rotating it clockwise until
tight and secure.
WARNING: DO NOT LOOK DIRECTLY INTO THE LASER BEAM OUTPUT /
LED BEAM OUTPUT APERTURE DURING OPERATION. PERMANENT EYE
DAMAGE MAY RESULT.
WARNING: EXERCISE SAFE GUN HANDLING. SHOOT ONLY AT AN
APPROVED GUN RANGE OR SUITABLE LOCATION. USE EYE AND EAR
PROTECTION AS NECESSARY.
7. MAINTAINING YOUR LASER SIGHT AND LED LIGHT
Do not attempt to disassemble or clean the laser sight or the LED Light internally.
This will invalidate the warranty. If the laser sight or the LED Light require repairs or
adjustment, complete instructions can be found in the warranty. The external surfaces
should occasionally be wiped clean with the lens cloth provided, a soft lint-free cloth,
or an optical quality lens paper. Remove any external dirt or sand with a soft brush so
as to avoid scratching the finish. Wipe the laser sight or the LED Light with a damp
cloth, following with a dry cloth. Store the unit in a moisture-free environment.
5
!
!
62120STSLLCP _62120STSLLGCP.qxd 12/4/09 4:38 PM Page 5