Kraus KEF-14607CH - Manual (Page 2)

Replacement Parts
Keep this manual for ordering replacement parts.
Trouble - Shooting
Problem Cause Action
Leaks underneath handle
Aerator leaks or has an inconsistent
water flow pattern.
Water will not shut off completely.
Adjusting ring or cap has come loose.
Aerator is dirty or misfitted.
Dirty or worn out plastic washer in the
cartridge.
Tighten the adjusting ring or cap.
Unscrew the aerator to check rubber packing
or replace the aerator.
Remove handle and cartridge to check if ceramic
disk is damage permanently or dirty.
Re-install cartridge.
Contact Us Toll-Free at 1-800-775-0703; or visit our website at www.kraususa.com 2008-2011 Kraus USA Inc.
Installation
Contact Us Toll-Free at 1-800-775-0703; or visit our website at www.kraususa.com 2008-2011 Kraus USA Inc.
O-ring
Plastic cover
Screw
O-ring
Decorative ring
Set screw
Decorative cap
Handle
Spanner for spout
Spout
Decorative cap
Set screw
Decorative board
Fixing board
Connecting pole
Plastic cover
Valve
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
17.
Place sufficient Teflon tape on hot/cold water supply
pipe lines. Insert them into the corresponding threaded
screw of valve 17 and install it into the wall. Open the
water supply to check if there is leakage. Loosen
screw 3 and take the plastic cover 2 off. Open the
cartridge to make sure there is no leakage. Close the
cartridge after checking. Remove plastic cover 16.
Open cartridge and remove the dirt in the pipe. Close
the cartridge and install the plastic cover 16 and 2 into
valve.
Seal the wall after checking for leakage. If there is
no leakage, remove plastic cover 16 and 2.
1
2
3
4
5
6
7 8
9
10
11
12
13
14
15
16
17
Cold water pipe
(NOT INCLUDED)
Hot water pipe
(NOT INCLUDED)
Cold water pipe
(NOT INCLUDED)
Hot water pipe
(NOT INCLUDED)
Cold water pipe
(NOT INCLUDED)
Hot water pipe
(NOT INCLUDED)
Place sufficient Teflon tape on connecting pole 15.
Screw it into corresponding screwed hole of valve 17
(If the connecting pole is too long please shorten it
with a saw; refer to dimensions for detail size). Install
decorative board 13 and Fixing board 14 to valve.
Install connecting pole 15 to the spout 10. Screw the
set screw 12 into spout 10 with alley key and install the
decorative cap 11. Install handle 8 to the corresponding
position to valve 17. Tighten decorative screw 6 with
alley key and place cap 7 afterwards.
1
2
3
4
5
6
7
9
8