Instrument cluster descriptions – Dodge 2012 Challenger - Owner Manual User Manual

Page 178

Advertising
background image

INSTRUMENT CLUSTER DESCRIPTIONS

1. Fuel Gauge
The pointer shows the level of fuel in the fuel tank when

the ignition switch is placed in the ON/RUN position.
2. Trip Odometer Button
Press this button to change the odometer line (bottom

line) in the Electronic Vehicle Information Center (EVIC)

from odometer to Trip Odometer A to Trip Odometer B

and back to odometer. Push in and hold the button for

two seconds to reset the displayed trip odometer to

0 miles (km). The trip odometer must be displayed to

reset it.
3. Speedometer
Indicates vehicle speed.

4. Electronic Speed Control Indicator Light

This light will turn on when the electronic

speed control is on.

5. Tachometer
The red segments indicate the maximum permissible

engine revolutions per minute (RPM x 1000) for each gear

range. Ease up on the accelerator before reaching the red

area.
6. Charging System Warning Light

This light shows the status of the electrical charg-

ing system. The light should turn on when the

ignition switch is placed in the ON/RUN position and

remain on briefly as a bulb check. If the light stays on or

turns on while driving, turn off some of the vehicle’s

non-essential electrical devices (i.e., radio) or slightly

increase engine speed (if at idle). If the light remains on,

176 UNDERSTANDING YOUR INSTRUMENT PANEL

Advertising